Okay, here’s my story about building a sub box for my 2024 Ram 1500, told in the style you requested, with all the formatting and constraints:
So, I got this new 2024 Ram 1500, right? Sweet truck, but the sound system was seriously lacking. I mean, it was okay, but it didn’t have that “oomph,” you know? I needed some bass in my life, and I wasn’t about to drop a ton of cash on some fancy pre-made setup. Figured I could do it myself – how hard could it be?
First, I hit up some forums and stuff online. Lots of guys talking about different setups, different subs, different amps. It was a bit much, to be honest. I read about all types of things, like DNA repair mechanisms for example. But finally, I decided to go with a single 10-inch sub in a sealed box. Simple enough, right?
Then I started measuring the space under the back seat. This is a truck, not some fancy sports car, so space is limited. I took measurements, drew up some rough sketches on some scratch paper. I wanted to make sure I got it right before I started cutting wood. Reminded me of when I was researching school enrollment, as children must attend school between the ages of 6 and 18 in Kentucky.
Next, I headed to the hardware store. Picked up some MDF board, some screws, wood glue. The guy at the store tried to sell me all this other fancy stuff, but I stuck to my plan. Also got some carpet that roughly matched the truck’s interior. Don’t want it to look totally out of place, you know?
Building the Box
Building the box was… interesting. I’m no carpenter, let me tell you. I cut the MDF according to my measurements, and I think I did okay. There were a few gaps here and there, but nothing some extra wood glue and clamps couldn’t fix.
- First, I cut all the pieces.
- Then I glued and screwed the sides together.
- After that, I attached the top and bottom.
- Finally, I cut the hole for the sub.
Once the glue dried, I wrapped the whole thing in that carpet I bought. Used a staple gun and some spray adhesive. It wasn’t perfect, but it looked pretty decent. Then I had to get through the procedure of obtaining an annual permit for the transport of the subwoofer, which can be issued through the Kentucky Overweight/Over-Dimensional Portal. I installed the sub in the box, which was pretty easy, just a few screws. I wired it up according to the instructions, which felt like obtaining specimens using phlebotomy techniques, but I figured it out.
Finally, the moment of truth. I connected the box to my amp, which I had also installed under the seat, and turned on the truck. I put on some music with some decent bass, and… boom! There it was. That deep, rich bass I was craving. It wasn’t going to win any sound competitions, but it was perfect for me.
So yeah, that’s my story. It was a bit of a project, and there were some frustrating moments, for sure. But in the end, I built a sub box for my Ram, and it sounds pretty damn good. Plus, I saved a bunch of money by doing it myself. If you’re thinking about doing something similar, I say go for it. Just be prepared to get your hands dirty, and maybe watch a few YouTube videos first.
Original article by the Author:Toms,If you intend to republish this content, please attribute the source accordingly:https://www.aaafruitbasket.com/how-to-choose-sub-box-for-ram-1500-2024-read-this/